1. Generally speaking, when making beautiful joints on the wall, the operation principle of first up and then down, from horizontal to vertical will be adopted. After filling a beautiful seam horizontally, and then filling the seam vertically, under the influence of gravity, the beautiful seam agent will flow down slowly, so this method is easier to operate.
2. First, fill the joints in the upper part of the wall, then the lower part, first high and then low, so that the construction method will not destroy the lower part due to the construction of the upper part of the wall, saving time and labor. The incision of the mixing pipe shall not be too small or too large, which is about the same as the gap size of the ceramic tile. After filling the joint, wait for 2 hours and then use the scraper to remove the excess sealant. When scraping, increase the strength, and make sure to use the scraper to smooth the sealant before it is completely solidified.
3. For the newly laid ceramic tiles, the gap shall be at least 1-3mm wide and 1-2mm deep, while the width of the antique ceramic tiles shall be 3mm in general. The gap shall be cleaned before filling, and the gap must be clean, flat and free of moisture. If the old ceramic tile is to be caulked again, the gap shall be cleaned with a knife, at least 1-3mm wide and 1-2mm deep, and the gap shall be cleaned and caulked again.
4. To fill the joint between the wall corner and the brick joint, a line with proper arc and wall gap size shall be plastered, and then the sponge shall be used for wiping. It shall be noted that the sponge shall not be too wet, and the strength shall be well controlled to make sure that the thickness of the line is the same, so as to achieve a three-dimensional effect.
5. Pay attention to:
(1) To choose a regular brand of the beauty sewing agent, the quality of the beauty sewing agent is a new kind of non-ferrous tasteless environmental protection materials. Before use, it can be sniffed lightly. If there is a pungent smell, it belongs to inferior caulking agent. This caulking agent not only fails to achieve the decorative effect of beautiful caulking, but also damages the health of our living environment at all times.
(2) If there is no peculiar smell in the seaming agent, it can be extruded a little and pulled to see if the consistency is qualified. If it is silky and does not break during the pulling process, it means that the consistency and adhesion are of good quality.
(3) After joint filling, observe whether the surface of the tacking agent is full, whether it will sag, etc.; wipe it with waste paper or old cloth at will. If the tacking agent is intact, it means that the hardness and quality of the tacking agent are high.
(4) A layer of waterproof protection will be formed after the sealant dries completely, so we can sprinkle a little water on the seam to see whether the sewage will penetrate, so as to judge the quality of the sealant.
American sewing is very easy to clean in later use, and does not need special maintenance. The use of seaming agent is not complicated. As long as attention is paid to the details before construction, the whole space decoration effect can be driven.
This article is dedicated by Shandong beauty sewing agent. For more information, please click http://www.jinanjiusun.com. We will answer your questions in detail. Welcome to log in the website and leave a message